Load tape bug: R&D Puzznic Level 3

Found a bug in R'n'D? Report it here!

Moderators: Zomis, Flumminator

Post Reply
Posts: 1501
Joined: Mon Jun 21, 2004 1:27 pm
Location: Sweden

Load tape bug: R&D Puzznic Level 3

Post by Zomis » Thu Dec 29, 2005 4:12 pm

I played a little R&D Puzznic today, and I'm on level 3 currently. However, I encountered a bug when I played it.
I had about 3 "puzznics"/blocks/whatever-you'd-like-to-call-'ems left when I did something stupid, I pushed down the wrong block. Very well I thought, then I'll just load the tape I just saved... but nope... the tape loads incorrectly somehow.
Around second 20, I push a red puzznic a little, but the block did not move. When I was playing it actually did move, but why didn't it do so now when I was loading the tape?

Note: This is not a solution tape, so the original tape (without the bug) doesn't actually completes the level, but keeps 3 puzznics left. I'll see if I can create a solution tape and the bug is still there.

I saved the tape using 3.2.0-5, i tested both 3.1.1 and 3.2.0-5 when loading it - same problem.
I have not tested saving tape with 3.1.1 though.

Post Reply