[MM 3.1.0] Laser can still be blocked off by a DF steel wall

Found a bug in R'n'D? Report it here!

Moderators: Flumminator, Zomis

Post Reply
User avatar
Eizzoux
Posts: 567
Joined: Wed Oct 30, 2013 5:32 am
Location: Russia
Contact:

[MM 3.1.0] Laser can still be blocked off by a DF steel wall

Post by Eizzoux »

bfkdsufkjdsf.png
bfkdsufkjdsf.png (14.64 KiB) Viewed 1027 times
While I was recreating Reflektor, this weird issue is still a thing for some reason, and I don't get why. Single DF steel wall for some reason can still behave like MM steel wall (edge of it blocks the way when it shouldn't).

Level and tape below:
002.level
(424 Bytes) Downloaded 62 times
002.tape
(916 Bytes) Downloaded 63 times
𒈟
User avatar
Holger
Site Admin
Posts: 4073
Joined: Fri Jun 18, 2004 4:13 pm
Location: Germany
Contact:

Re: [MM 3.1.0] Laser can still be blocked off by a DF steel wall

Post by Holger »

Yes, I was able to reproduce this. Very strange behavior! Especially as I did tests with the following results:

- replay of attached tape for attached level: bug occurs as described
- playing that same level myself, with same laser route: bug occurs again
- playing another time, as above: bug does not occur this time

So apparently this bug is not exactly deterministic (at least it looks like that). But I don't think that it really occurs randomly, but apparently due to some buggy internal state values.

I will further investigate this problem and check if I am able to find the reason for this bug.

Thanks for reporting this!
Post Reply