Rocks'n'Diamonds

Posted: **Sun Jun 24, 2007 4:28 pm**

viewtopic.php?t=1337

(Lol, 1337!)

Anyways, Holger said it would be a new function in the prerelease. I checked out the Shift+Click, which works, and is awesome (it even turns base into buggy base!

), but Intellidraw for conveyor belts etc. isn't there as far as I see. When is it getting in?

Posted: **Tue Jun 26, 2007 12:33 pm**

It should already work: Select any conveyor belt element and then use the line drawing tool, for example. (You need the latest pre-release for this.)

Posted: **Wed Jun 27, 2007 5:01 pm**

If you mean 3.2.4-1, then I can't get it to work somehow. :/

Posted: **Wed Jun 27, 2007 6:40 pm**

Are you sure that you were using the line tool instead of one of the freeform drawing tools?

Posted: **Fri Jun 29, 2007 12:55 am**

I don't like using pre-release versions, but I'm seriously looking forward to this whole intellidraw deal when the next official release comes!

Posted: **Fri Jun 29, 2007 4:21 pm**

Daniel H. wrote:Are you sure that you were using the line tool instead of one of the freeform drawing tools?

I'm sure. Does it work for you?

Rocks'n'Diamonds

Where did 'Intellidraw' go? :)

Where did 'Intellidraw' go? :)