2. turn on single step mode
3. quick save (f1)
4. exit to menu
5. quick load (f2)
- 1step.png (1.52 KiB) Viewed 278 times
- 1step_ok.png (2 KiB) Viewed 278 times
"1-step" indicator is drawn below deactivated "play" indicator if you load a tape that was saved in single-step mode
Moderators: Flumminator, Zomis
"1-step" indicator is drawn below deactivated "play" indicator if you load a tape that was saved in single-step mode
1. enter a level
2. turn on single step mode
3. quick save (f1)
4. exit to menu
5. quick load (f2)
see that cyan dash next to the gray PLAY? that's the "-" of "1-STEP". after you make any movement, it will display properly:
(i have also gotten a bug where the pause button displays over the menu door in certain cases if single-step is enabled, but i can't remember exactly what i did. will make a topic for that when i find out how to reproduce it)
2. turn on single step mode
3. quick save (f1)
4. exit to menu
5. quick load (f2)
see that cyan dash next to the gray PLAY? that's the "-" of "1-STEP". after you make any movement, it will display properly:
(i have also gotten a bug where the pause button displays over the menu door in certain cases if single-step is enabled, but i can't remember exactly what i did. will make a topic for that when i find out how to reproduce it)